Skip to content
Australian Government - Department of Foreign Affairs and Trade

Advancing the interests of Australia and Australians internationally

Australian Government - Department of Foreign Affairs and Trade

Advancing the interests of Australia and Australians internationally

Australian Safeguards and Non-Proliferation Office

Annual Report 1999-2000

Output A Operation of SSAC

Operation of Australias national system of accounting for, and control of, nuclear material and items subject to IAEA safeguards, including promotion and regulation, within Australia, of effective measures for the physical protection of nuclear facilities and material.

Milestone A1

A1.1 The provisions of the Nuclear Non-Proliferation (Safeguards) Act 1987 administered effectively.

A1.2 The continued adequacy of the Acts provisions reviewed and evaluated.

A1.3 Under the Acts Permit System, nuclear items in Australiaincluding those subject to bilateral safeguards agreementscontrolled and accounted for effectively.

Activities

Permits and authorities

During the year two new permits or authorities under the Safeguards Act were issued, none expired and none were revoked. The conditions of three permits were varied.

Table 3 Status of Safeguards Permits and Authorities in Australia

Permit or Authority to:

Granted

Varied

Expired

Number at End of Period

Total

2

3

0

91

Possess nuclear material

1

3

0

31

Possess associated items

0

0

0

21

Transport nuclear material

1

0

0

22

Transport associated items

0

0

0

0

Communicate information contained in associated technology

0

0

0

17

Laser enrichment R&D

An Australian company, Silex Systems Limited, is researching an innovative method of separating uranium isotopes using laser techniques. In 1996 the company entered into an agreement with the United States Enrichment Corporation (USEC) to explore the commercial potential of this technology. In the first phase, Silex demonstrated the technology to USEC specialists. If further development work in successive phases is successful, the technology may be commercialised in the United Statesthis aspect is discussed further under Milestone B2 (on page 29).

Picture: Development of Silex enrichment technology - photograph courtesy of Silex Systems Ltd.

Development of Silex enrichment technology - photograph courtesy of Silex Systems Ltd.

ASNO is following the progress of this research closely, since the Silex technology will have to be classified as associated technology and associated equipment under the Safeguards Act if it proves practicable for the enrichment of nuclear material, or if it is considered that details of the technology could be useful for others working in the enrichment field. ASNOs objective here is to ensure that nuclear technology remains in exclusively peaceful use and does not contribute to any proliferation efforts. Classification as associated technology will have the result of restricting access to the technology to authorised persons. ASNO is also concerned to ensure that all IAEA reporting requirements with respect to nuclear-related R&D are met. In anticipation that the Silex process may become associated technology, ASNO has already put in place appropriate security measures to ensure against unauthorised access.

Data reported pursuant to the Safeguards Act

As required by sub-section 51(2) of the Safeguards Act, details of nuclear material and associated items of Australian origin, and nuclear material and associated items within Australia, regardless of origin, are set out in Annexes to this Report as follows:

Annex A: Nuclear Material within Australia at 30 June 2000.

Annex B: Associated Items within Australia at 30 June 2000.

Annex C: Australian Obligated Nuclear Material Overseas:

(i) Locations and Quantities of AONM at 31 December 1999.

(ii) Transfers of AONM during 1999.

As in previous years, no associated items of Australian origin are located overseas.

ASNO also provides the Australian National Audit Office with a statement each year of holdings of nuclear items by ANSTO.

Performance Assessment

Administration of the Permit System was carried out in a timely manner, with all changes published in the Commonwealth of Australia Gazette as required by the Safeguards Act. All nuclear material and nuclear items within Australia were satisfactorily accounted for as at 30 June 2000.

Milestone A2

IAEA safeguards implemented satisfactorily in Australia.

Activities

Australias State System of Accounting for and Control of Nuclear Material (SSAC)is operated by ASNO in accordance with Australias safeguards agreement with the IAEA. ASNO reports to the IAEA on the disposition of nuclear material in Australia and assists inspections carried out by the IAEA at Australian facilities.

Reports on the disposition of nuclear material

Each month an ASNO officer carries out an audit of the inventory of nuclear material at the ANSTO site at Lucas Heights (near Sydney), which is the principal location of safeguardable nuclear material in Australia. Changes during the month in that inventory (as well as any changes elsewhere in Australia) are reported by ASNO to IAEA headquarters in Vienna. Accounting reports are also given to the IAEA by ASNO following the IAEA inspections described below.

Details of Australian Accounting Reports to the IAEA during the year are at Annex D.

IAEA inspections in Australia
Picture: ASNO inspector assists IAEA in collection of environmental samples - photograph courtesy of ANSTO

ASNO inspector assists IAEA in collection of environmental samplesphotograph

As in other countries covered by IAEA safeguards, the Agency carries out routine inspections of Australian nuclear facilities. The aim of these inspections is to verify that nuclear material inventories are as declared by the operator and the SSAC. Each inspection deals with what is described as a Material Balance Area (MBA), of which Australia has five, as listed in Table 4.

IAEA inspectors visited Australia on 5 occasions during 1999-2000 to carry out routine inspections (see Annex D for details).

Table 4 Material Balance Areas in Australia
Location MBA Facility

ANSTO

AS-A

HIFAR reactor

ANSTO

AS-B

Moata reactor[2]

ANSTO

AS-C

Research and Development Laboratories

ANSTO

AS-D

Vault Storage

Elsewhere

AS-E

Other locations in Australia

[2] In February 1995 the ANSTO Board decided to cease operation of Moata, and the reactor was defuelled in May 1995.

ASNO, as the national safeguards authority, acts as the intermediary between the IAEA and the facility operator on all safeguards matters. An ASNO officer accompanies IAEA inspectors during inspections in Australia. The officer ensures the inspectors are able to carry out their duties, so that Australia meets its obligations, and mediates on any issues arising between the IAEA and the facility operator. In particular, ASNO assists in the resolution of any inconsistencies discovered during inspections, thus simplifying the IAEA inspectors task.

A major focus of IAEA inspection activity is the identification and evaluation of material unaccounted for (MUF), that is, the difference between the records maintained by the operator (the ending book inventory) and the physical inventory verified by the IAEA. Since MUF is the difference between two measured quantities, it may be equal to zero, or it may be either a positive or negative value. If MUF is positive it does not necessarily indicate that material has been lost, nor does a negative figure mean that material has somehow been created. In the normal course, some measurement differences are expected. There was a small MUF of enriched uranium declared for MBA AS-C (R&D Laboratories) during the year. The Physical Inventory for this MBA was less than the Book Inventory by 4.73 grams of uranium element and 0.10 grams of U-235 isotope.

The IAEA reports all conclusions drawn from its routine safeguards inspections in Australia, including comments on any MUF, in the statements provided pursuant to Article 91(b) of Australias NPT safeguards agreement. A summary of Statements provided during the year for Material Balance Areas AS-A, B, C and D and an explanatory note on MBA AS-E are at Annex E of this Report.

Declaration of Safeguards Inspectors

Under section 57 of the Safeguards Act, the Minister may declare a person to be an Inspector for the purposes of the Act. In practice, this applies only to officers of ASNO. The role of an Inspector is to ensure compliance with provisions of the Safeguards Act and to assist IAEA inspectors in the conduct of Agency inspections in Australia. No new national inspectors were declared in 1999-2000.

The Minister may declare a person designated by the IAEA as an Agency Inspector for the purpose of the Safeguards Act. In practice, all IAEA staff designated to Australia are declared under the Safeguards Actthere were 21 new designations during 1999-2000. There are currently 181 IAEA staff declared as Agency Inspectors pursuant to the Act.

Since 1990, inspector appointment and declaration powers have been delegated by the Minister to the Director of Safeguards.

Performance Assessment

All routine IAEA inspections were concluded satisfactorily and all apparent discrepancies were resolved.

IAEA statements during 1999-2000 confirm that all of Australias IAEA safeguards obligations were discharged satisfactorily and, specifically, that Australias records had been maintained in accordance with prescribed practice. ASNOs reporting fully satisfies IAEA requirements.

The IAEA has never found cause to comment adversely on Australias accounting for and control of nuclear materiala fact reflected in Article 91(b) statements over the years.

Milestone A3

A3.1 Appropriate physical protection measures for nuclear material in Australia reviewed; sites holding nuclear items audited to ensure that prescribed physical protection measures have been implemented effectively.

A3.2 Sites holding nuclear items audited to ensure that prescribed physical protection measures have been implemented effectively.

Activities

Physical Protection within Australia

ASNO is responsible for prescribing the levels of physical protection, or security, to be applied to nuclear items subject to the Safeguards Act. During the year, inspections were carried out of the physical protection measures applied at ANSTO. Inspections were also carried out of the physical protection measures applied at, and in connection with, the uranium mining operations in South Australia and the Northern Territory. In addition, regular inspections were made of the arrangements put in place for the protection of potentially sensitive information relating to the Silex laser enrichment R&D project.

Performance Assessment

Physical protection requirements prescribed by ASNO are consistent with the most recently agreed international standards.

All physical protection inspections undertaken by ASNO had satisfactory outcomes: ANSTO, the uranium mines and associated operations, and Silex were all confirmed to be applying appropriate levels of physical protection.

Return to the ASNO Annual Report Index | Output BBilateral Safeguards

Department of Foreign Affairs and Trade